...ch a line discipline to a serial line SYNOPSIS ldattach [ -1278denoVh ] [ -i iflag ] [ -s speed ] ldisc device DESCRIPTION The ldattach daemon opens the specified device file (w…...packet in the queue can be sent. If it is not acceptable to burst out packets at maximum speed, a peakrate can be configured to limit the speed at which the bucket empties. This…...ed rate, which implies no borrowing burst bytes Amount of bytes that can be burst at ceil speed, in excess of the configured rate. Should be at least as high as the highest burs…...m and the information stored within them is used by the man-db utilities to enhance their speed and functionality. When creating or updating an index , mandb will warn of bad RO…...e produced by Hayes(tm)-compatible modems. These status messages are of the form: "<junk><speed><junk>". agetty assumes that the modem emits its status message at the same speed…...e produced by Hayes(tm)-compatible modems. These status messages are of the form: "<junk><speed><junk>". agetty assumes that the modem emits its status message at the same speed…...above overheads in this case. If you're shaping directly on the router (for example, with speedtouch usb modem) using ppp daemon, you're using raw ip interface without underlyin…...r a float followed by a '%' character to specify the rate as a percentage of the device's speed (e.g. 5%, 99.5%). Warning: specifying the rate as a percentage means a fraction o…...k-conserving) qdiscs, is only useful if it owns the queue. This is the case when the link speed equals the actually available bandwidth. This holds for regular phone modems, ISD…...[ CELLSIZE [ CELLOVERHEAD ]]] Delays packets based on packet size to emulate a fixed link speed. Optional parameters: PACKETOVERHEAD Specify a per packet overhead in bytes. Used…...s. CAKE defaults to splitting GSO packets to achieve the lowest possible latency. At link speeds higher than 10 Gbps, setting the no-split-gso parameter can increase the maximum…mount a filesystem NAME mount - mount a filesystem SYNOPSIS mount [ -h | -V ] mount [ -l ] [ -t fstype ] mount -a [ -fFnrsvw ] [ -t fstype ] [ -O optlist ] mount [ -fnrsvw ] [ -o o…