...or 100, but the values are reserved for future use. LIRC_GET_MIN_TIMEOUT( void ) LIRC_GET_MAX_TIMEOUT( void ) Some devices have internal timers that can be used to detect when t…...ality reports the quality of the modulation on the air (direct sequence spread spectrum) [max = 16]. Level and Noise refer to the signal level and noise level [max = 64]. The cr…...of the message. FUSE_INIT struct fuse_init_in { uint32_t major; uint32_t minor; uint32_t max_readahead; /* Since protocol v7.6 */ uint32_t flags; /* Since protocol v7.6 */ }; Th…...on: 7.14 IRQ: 16 Logical drives: 1 Current Q depth: 0 Current # commands on controller: 0 Max Q depth since init: 1 Max # commands on controller since init: 2 Max SG entries sin…...S_RESOURCE capability) can set frequencies above the value specified in /proc/sys/dev/rtc/max-user-freq . (This file contains the value 64 by default.) RTC_AIE_ON RTC_AIE_OFF En…...4_t lo_rdevice; /* ioctl r/o */ uint64_t lo_offset; uint64_t lo_sizelimit; /* bytes, 0 == max available */ uint32_t lo_number; /* ioctl r/o */ uint32_t lo_encrypt_type; uint32_t…...4_t lo_rdevice; /* ioctl r/o */ uint64_t lo_offset; uint64_t lo_sizelimit; /* bytes, 0 == max available */ uint32_t lo_number; /* ioctl r/o */ uint32_t lo_encrypt_type; uint32_t…...nds. It influences only the polling driver. int ioctl(int fd , LPCHAR, int arg ) Sets the maximum number of busy-wait iterations which the polling driver does while waiting for …...w). (By changing compile-time constants, it is possible to change the balance between the maximum number of tape drives and the number of minor numbers for each drive. The defau…